Cheng Yu
University of North Texas
USA
Title: Screw connections in cold-formed steel clip angles subjected to uplift forces
Biography
Biography: Cheng Yu
Abstract
The paper presents a test program aimed at investigating the pull-over strength of screws installed on the anchored leg of the cold-formed steel clip angle connectors. Initial confirmatory tests showed that the tested pull-over strength was significantly less than the predicted values that were determined using AISI S100 (2012). Therefore, additional specimens were tested in order to develop an appropriate design method for the pull-over strength of screws used in CFS clip angles. The test results indicated that the pull-over strength of screws when used in clip angles would experience 50% reduction in nominal strength. A proposal to revise the current design provision in AISI S100 was presented in this paper along with complete details of the test program.